ASSEMBLY
ASSEMBLY INSTRUCTIONS:
GRASS DEFLECTOR
See Figure 4.
1.Remove wing nut, flat washer, lock washer, and bolt from the Owner’s Kit.
2.Place grass deflector over shaft and bracket.
3.Install bolt through the slots in the tabs on grass deflector and bracket on driveshaft housing.
4.Install flat washer, lock washer and wing nut.
5.Tighten Securely.
BOLT | GRASS |
| DEFLECTOR |
BRACKET
LOCK WASHER
FLAT |
|
|
WASHER | WING NUT | Fig. 4 |
| ||
|
|
FRONT HANDLE
See Figure 5.
1.Place the handle base and the bracket on the driveshaft housing below the spacer.
2.Install the two handle base screws and nuts, but do not tighten completely.
3.Place the handle grip onto the handle base and install the two screws. Tighten securely.
4.Adjust the position of the handle for best balance and comfort.
5.Tighten the two handle base screws securely.
NOTE: Do not attempt to remove or modify the spacer. This spacer limits the upper position of the handle grip. See
Figure 5.
HANDLE BASE
SCREWS
HANDLE
BASE
BRACKET
NUTS
SPACER
HANDLE GRIP
SCREWS
Fig. 5
