OPERATION
FUEL AND REFUELING
HANDLING THE FUEL SAFELY
■Always handle fuel with care, it is highly flammable.
■Always refuel outdoors where there are no sparks and flames. Do not inhale fuel vapors.
■Do not let gasoline or oil come in contact with your skin.
■Keep gasoline and oil away from the eyes. If gasoline or oil comes in contact with the eyes, wash them immedi- ately with clean water. If irritation is still present, see a doctor immediately.
■Clean up spilled fuel immediately.
MIXING THE FUEL
■This product is powered by a
■This engine is certified to operate on unleaded gasoline intended for automotive use with an octane rating of 87 ([R + M] / 2) or higher.
■Do not use any type of
■Use high a quality
■Mix 2% oil into the gasoline. This is a 50:1 ratio.
■Mix the fuel thoroughly and also each time before fueling.
■Mix in small quantities. Do not mix quantities larger than usable in a 30 day period. A
FILLING THE TANK
1.Clean surface around fuel cap to prevent contamination.
2.Loosen fuel cap slowly to release pressure and to keep fuel from escaping around the cap.
3.Carefully pour fuel mixture into the tank. Avoid spillage.
4.Prior to replacing the fuel cap, clean and inspect the gasket.
5.Immediately replace fuel cap and hand tighten. Wipe up any fuel spillage. Move 9 m (30 ft.) away from refueling site before starting engine.
NOTE: It is normal for smoke to be emitted from a new engine during and after first use.
WARNING
Always shut off engine before fueling. Never add fuel to a machine with a running or hot engine. Move at least 9 m (30 ft.) from refueling site before starting engine. Do not smoke!
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 1 Litre | + |
| 20 ml | = | } |
| |
| 2 Litres | + |
| 40 ml | = |
| ||
| 3 Litres | + |
| 60 ml | = |
| ||
| 4 Litres | + |
| 80 ml | = |
| ||
| 5 Litres | + |
| 100 ml | = |
| ||
OPERATING THE TRIMMER
See Figure 7.
Hold the trimmer with the right hand on the rear handle and the left hand on the front handle. Keep a firm grip with both hands while in operation. Trimmer should be held at a comfortable position with the rear handle about hip height.
Always operate trimmer at full throttle. Cut tall grass from the top down.This will prevent grass from wrapping around the driveshaft housing and string head which may cause damage from overheating. If grass becomes wrapped around the string head, stop the engine, disconnect the spark plug wire, and remove the grass. Prolonged cutting at partial throttle will result in oil dripping from the muffler.
Fig. 7
10
