ADJUSTMENTS

TO ADJUST DEPTH OF CUT USING OPTIONAL DEPTH CONTROL KNOB

See Figure 9.

UNPLUG YOUR ROUTER.

WARNING:

Failure to unplug your router could result in acciden- tal starting casuing serious injury.

Loosen lock knob and raise stop bar.

Unlock plunge lock lever and raise cutter to its up-

permost position.

Plunge router until cutter reaches the approximate

desired depth of cut.

Lock plunge lock lever, temporarily locking cutter at

desired depth of cut.

Turn depth control knob clockwise until hex nut seats

against stop flange. Do not overtighten.

Unlock plunge lock lever. Always unlock plunge

lock lever before setting depth of cut with depth

OPTIONAL DEPTH

CONTROL KNOB

PLUNGE

LOCK

LEVER

DEPTH

COMPRESSION

HEX NUT

ADJUSTMENT

ROD

SPRING

 

 

 

Fig. 9

control knob.

Turn depth control knob until cuter reaches desired

depth of cut.

Lock plunge lever. Always lock cutter in place

before routing.

Loosen lock knob and adjust stop bar until it touches

depth stop.

Tighten lock knob securely.

DEPTH STOP

See Figures 10 and 11.

The depth stop is located on the base of your router and makes it possible to make deep or heavy cuts in successive passes by use of the Accu-Stop™ Micro- Adjustable Depth Stop System. Alignment marks make depth of cut changes quick and easy.

DEPTH STOP

KNOB

LOCK

KNOB

STOP

BAR

ACCU-STOPTM

MICRO-ADJUSTABLE

DEPTH STOP

EACH 90° ROTATION OF DEPTH

STOP KNOB EQUALS 1/64 in.

(0.4 mm) CHANGE IN DEPTH OF CUT

Fig. 10

A preset cutting depth is achieved by plunging router until stop bar comes in contact with depth stop. The micro-adjusting feature provides alignment marks at each 90° rotation of the depth stop knob. Each 90° rotation of the knob changes depth of cut setting 1/64 in. (0.4 mm). See Figure 10.

A complete rotation (360°) of the depth stop knob changes the depth of cut setting 1/16 in. (1.6 mm). See Figure 11.

The Accu-Stop™ Micro-Adjustable Depth Stop System provides for depth of cut changes to be made from 0 to 1/2 in. (12.7 mm) from the initial setting of the stop bar. This initial setting of the stop bar can be "zero" depth of cut, or it can be any depth of cut setting that you choose as a starting point for a particular job to be performed.

SCALE

ZERO RESET INDICATOR

WITH RED LINE

LOCK

KNOB

STOP

BAR

EACH COMPLETE ROTATION 360° OF DEPTH STOP KNOB

EQUALS 1/16 in. (1.6 mm)

CHANGE IN DEPTH OF CUT

Fig. 11

13

Page 13
Image 13
Ryobi RE180PL1 manual Depth Stop, To Adjust Depth of CUT Using Optional Depth Control Knob, Change in Depth of CUT