ASSEMBLY
TO ATTACH THE FEATHERBOARDS
See Figure 9
13.Insert the hex head screw (AJ) into the sliding block
(J).Place the sliding block into the slot of the feather- board (H). Secure by placing washer (AE) over the hex head screw (AJ). Screw together by turning the knob
(S)clockwise. NOTE: Do not completely tighten at this stage. Repeat the above for the remaining 2 feather- boards.
ASSEMBLE THE MITER GUIDE
See Figure 11
15.Place the miter guide head (E) on top of the miter bar
(X). Now fasten together by screwing the self tapping screw (AF) into the miter guide head. Assemble miter guide by threading carriage bolt (AA) through miter bar
(X). Place washer (AE) and knob (S) on end of carriage bolt. Tighten knob and then attach miter pointer (W) to rear of miter bar (X) with self tapping screw (AF).
AJ (3)
AE (3)
AA (1)
S
AE
H
J
AJ
Fig. 9
See Figure 10
14.Position 2 of the featherboards on the fence and secure by turning the knobs (S) clockwise. Place the third featherboard into the slot provided on the table- top and tighten in the same way.
S
S
Fig. 10
AE (1) | AF (2) |
S
AF
AE
W
E
X
AA
AF
Fig. 11
WARNING:
Before mounting the router make sure you have read and understood pages
13
