ASSEMBLY
UNPACKING
This product requires assembly.
nCarefully remove the product and any accessories from the box. Make sure that all items listed in the packing list are included.
nInspect the product carefully to make sure no breakage or damage occurred during shipping.
nDo not discard the packing material until you have care- fully inspected and satisfactorily operated the product.
nIf any parts are damaged or missing, please call
Packing List
Blower
Upper Blower Tube Sweeper Nozzle High Velocity Nozzle Vacuum Handle Vacuum Handle Knobs (2) Grounding Wire
Upper and Lower Vacuum Tubes Vacuum Tube Screws (2) Vacuum Bag Assembly Vacuum Bag Adaptor
Operator’s Manual
NOTE: Read and remove all hang tags and store with your operator’s manual.
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced. Failure to heed this warning could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create accessories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.
ASSEMBLING THE BLOWER TUBES
See Figure 2.
Align raised tabs on main housing to the slots on upper tube; slide together and tighten securely by twisting. Check tightness after initial run and retighten if needed.
To remove the tubes, rotate the tubes to unlock them and remove from the blower housing outlet.
instalLING THE Vacuum handle
See Figure 3.
Lay unit on side as shown.
Insert vacuum handle into the base of unit.
Secure vacuum handle in place using two knobs as shown.
sweeper nozzle
upper blower
tube
Fig. 2
vacuum handle
vacuum handle knobs
Fig. 3
