Ryobi RY09907 Operating The Blower, Cruise control, Operation, See Figures, tHROTTLE TRIGGER

Models: RY08554 RY09907

1 22
Download 22 pages 41.34 Kb
Page 14
Image 14
OPERATING THE BLOWER

OPERATION

OPERATING THE BLOWER

See Figures 11 - 12.

See Figures 11 - 12. WARNING:

Never run the unit without the blower tubes installed or the vacuum door securely closed. Failure to heed this warning could result in serious personal injury.

Start the blower. Refer to Starting and Stopping earlier in this manual. Hold the blower with the upper handle in your right hand.

WARNING:

Keep away from all hot surfaces of the blower. Failure to do so could result in possible serious personal injury.

To keep from scattering debris, blow around the outer edges of a debris pile. Never blow directly into the center of a pile.

Operate power equipment at reasonable hours only - not early in the morning or late at night when people might be disturbed. Comply with the times listed in local ordi- nances.

To reduce sound levels, limit the number of pieces of equipment used at any one time.

Conserve water by using power blowers instead of hoses for many lawn and garden applications, including areas such as gutters, screens, patios, grills, porches, and gardens.

Operate blower at the lowest possible throttle speed to do the job.

Check your equipment before operation, especially the muffler, air intakes, and air filters.

Use rakes and brooms to loosen debris before blowing.

In dusty conditions, slightly dampen surfaces when water is available.

Watch out for children, pets, open windows, or freshly washed cars, and blow debris safely away.

Use the full blower nozzle extension so the air stream can work close to the ground.

After using blowers or other equipment, CLEAN UP! Dispose of debris properly.

Use the sweeper nozzle for the everyday blowing opera- tion. This nozzle allows for more area to be covered during the blowing operation.

The high velocity nozzle is specifically designed for wet sticky leaves. It allows you to scrape wet leaves or debris while operating the blower.

sweeper nozzle

high velocity

nozzle

 

Fig. 12

CRUisE

tHROTTLE TRIGGER

CONTROL

 

Fig. 13

Cruise control

See Figure 13.

The cruise control can be used to operate the blower without holding the throttle trigger.

To engage the cruise control:

Pull cruise control lever back towards user, and stop at the desired throttle setting.

To release the cruise control, push cruise control lever all the way towards the front of unit.

14

Page 14
Image 14
Ryobi RY09907, RY08554 Operating The Blower, Cruise control, Operation, See Figures, sweeper nozzle high velocity nozzle