OPERATION
CONNECTING TO POWER SUPPLY
See Figure 5.
This product is designed with a cord retainer that prevents the extension cord from being pulled loose while using.
nForm a loop with the end of the extension cord.
nInsert loop portion of extension cord through opening in the bottom of the rear handle and place over cord retainer.
nSlowly pull loop against cord retainer until the
slack is removed .
nPlug product into extension cord.
NOTE: Failure to remove all excess cord slack from extension cord retainer could result in plug loosening from receptacle.
STARTING AND STOPPING
See Figure 5.
To start the motor:
nConnect the pole saw to power supply.
n Place your thumb on the
n Fully depress the switch trigger.
To stop the motor:
nRelease the switch trigger.
LOCK-OUT
BUTTON
SWITCH TRIGGER
CORD RETAINER
Fig. 5
ADJUSTING TELESCOPING POLE
See Figure 6.
nDisconnect the pole saw from the power sup- ply.
nRotate the collar counterclockwise to loosen.
n Push poles towards each other to shorten the pole or pull away from each other to lengthen the pole.
NOTE: Extend the pole only to the length required to reach the limb being cut. Do not extend the handle above waist height.
n When the desired length is achieved, rotate the collar clockwise to secure.
NOTE: Adjust hand placement on the shaft of the pole saw to keep proper balance. Do not attempt to use the pole saw at a length which does not allow you to achieve proper footing and balance at all times.
Page 13 — English
