Ryobi SS180 REMOVING DEPTH ADJUSTMENT RING, ASSEMBLING CIRCLE CUTTER, ATTACHING CIRCLE CUTTER, TAB, NUT, SCREW, NOTE:, WRENCH, HANDLE, ADAPTOR

ADJUSTMENTS

See Figure 4.

Follow these directions when removing the depth adjustment ring.

■Place wrench in tab on depth adjustment ring.

■Depress spring-loaded tab.

■Lift depth adjustment ring off of tool.

See Figure 5.

Follow these directions when assembling the circle cutter.

■Attach handle with screw provided.

■Attach pivot point knob with nut provided.

See Figure 6.
Follow these directions when attaching the circle cutter.	Fig. 4
Follow these directions when attaching the circle cutter.
■ REMOVE BATTERY PACK FROM SPEED SAW.
■ REMOVE BATTERY PACK FROM SPEED SAW.

WARNING:

NUT

Failure to remove battery pack could result in accidental starting causing serious injury.

■ Assemble circle cutter if necessary. Refer to “AS- SEMBLING CIRCLE CUTTER” previously.

■ Remove bit if necessary. Refer to “INSERTING/ REMOVING BITS” earlier in this manual.

■ Place adaptor under depth adjustment ring.

NOTE: Make sure the adaptor fits snugly.

■ Place circle cutter arm on top of depth adjustment		HANDLE
■ Place circle cutter arm on top of depth adjustment		PIVOT POINT
	ring.	PIVOT POINT
	ring.	KNOB	Fig. 5
■	Screw threaded ring onto adaptor, securing circle	KNOB


	cutter arm.
■ Insert bit. Refer to “INSERTING/REMOVING BITS”		THREADED
	earlier in this manual.	THREADED
	earlier in this manual.	RING
		RING
			CIRCLE
			CUTTER
			ARM
		DEPTH
		ADJUSTMENT
		RING

Fig. 6