OPERATION
USING CIRCLE CUTTER
See Figure 10.
Follow these directions when using the circle cutter.
■ Assemble circle cutter if necessary. Refer to “AS- SEMBLING CIRCLE CUTTER” earlier in this manual.
■Attach circle cutter to Speed Saw if necessary. Refer to “ATTACHING CIRCLE CUTTER” earlier in this manual.
■ Adjust depth of cut if necessary. Refer to “ADJUST- ING DEPTH OF CUT” earlier in this manual.
■Loosen pivot point knob.
■ Move pivot point knob to desired diameter dimen- sion.
■ Tighten pivot point knob. |
|
■ Start Speed Saw. |
|
■ Cut a pilot hole in the center of the intended circle. |
|
■ Line up pivot point knob with the lead hole. | Fig. 10 |
|
■Begin cut, applying moderate, steady pressure.
■Hold the Speed Saw firmly with one hand and the handle with the other.
CAUTION:
Too much force causes heat build up, which can shorten the life of the bit.
■Work in a clockwise direction, continuing back to the starting position.
■Stop Speed Saw.
12