| GENERAL SAFETY RULES |
SERVICE | ■ When servicing a tool, use only identical replace- |
■ | Tool service must be performed only by quali- | ment parts. Follow instructions in the Mainte- | |
nance section of this manual. Use of unauthorized | |||
| fied repair personnel. Service or maintenance per- | ||
| parts or failure to follow Maintenance Instructions | ||
| formed by unqualified personnel could result in a risk | ||
| may create a risk of shock or injury. | ||
| of injury. | ||
|
|
SPECIFIC SAFETY RULES
Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator.
ADDITIONAL SAFETY RULES
■Know your power tool. Read operator's manual carefully. Learn its applications and limitations, as well as the specific potential hazards related to this tool. Following this rule will reduce the risk of electric shock, fire, or serious injury.
■Secure work. Use clamps or a vise to hold work when practical. It is safer than using your hand and frees both hands to operate tool.
■Make sure your extension cord is in good condi- tion. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. A wire gage size (A.W.G.) of at least 16 is recommended for an extension cord 100 feet or less in length. A cord exceeding 100 feet is not recommended. If in doubt, use the next heavier gage. The smaller the gage number, the heavier the cord. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating.
WARNING:
Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
•lead from
•crystalline silica from bricks and cement and other masonry products, and
•arsenic and chromium from
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.
CORDLESS TOOL RULES
■Cordless tools do not have to be plugged into an electrical outlet; therefore, they are always in operating condition. Be aware of possible haz- ards when not using your cordless tool or when changing accessories. Following this rule will re- duce the risk of electric shock, fire, or serious per- sonal injury.
■Do not place cordless tools or their batteries near fire or heat. This will reduce the risk of explo- sion and possibly injury.
WARNING:
Batteries vent hydrogen gas and can explode in the presence of a source of ignition, such as a pilot light. To reduce the risk of serious personal injury, never use any cordless product in the presence of open flame. An exploded battery can propel debris and chemical. If exposed, flush with water immediately.
■Do not charge cordless tool in a damp or wet location. Following this rule will reduce the risk of electric shock.
■For best results, your cordless tool should be charged in a location where the temperature is more than 50°F but less than 100°F. Do not store outside or in vehicles.
■Under extreme usage or temperature conditions, battery leakage may occur. If liquid comes in contact with your skin, wash immediately with soap and water, then neutralize with lemon juice or vinegar. If liquid gets into your eyes, flush them with clean water for at least 10 minutes, then seek immediate medical attention. Following this rule will reduce the risk of serious personal injury.
4