Ryobi SS725r manual Operating Instructions, Operating The Click-Link System

OPERATING INSTRUCTIONS

OPERATING THE CLICK-LINK® SYSTEM

The Click-Link® system enables the use of these optional add-ons.

Blower/Vacuum . . . . . . . . . . . . . . . . . . . . . . . . . . BV720r Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GC720r Hedge Trimmer (Gas units only) . . . . . . . . . . . . . HS720r Snow Thrower (Gas units only) . . . . . . . . . . . . . . ST720r Tree Pruner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TP720r Sweeper/Blower . . . . . . . . . . . . . . . . . . . . . . . . . SB720r Lawn Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LE720r Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . TB720r

WARNING: Read and understand operator’s manual for unit to be used with this add-on prior to operation.

Removing the Add-Ons:

1.Turn the knob counterclockwise to loosen (Fig. 1).

2.Press and hold the release button (Fig. 2).

3.While firmly holding the upper shaft housing, pull the cutting attachment or add-on straight out of the Click-Link® coupler.

Installing the Add-Ons:

WARNING: To avoid serious personal injury, shut unit off before removing or installing add-ons.

NOTE: To make installing or removing the add-on easier, place the unit on the ground or on a work bench.

1. Turn the knob counterclockwise to loosen (Fig. 1).

Click-Link®Coupler Release Button

Knob	Guide
	Recess

Fig. 1

2.While firmly holding the add-on, push it straight into the Click-Link® coupler (Fig. 2).

NOTE: Aligning the release button with the guide recess will help the installation (Fig. 2).

Click-Link®Coupler Release Button

Primary Hole

Upper Shaft		Lower Shaft
Housing
		Housing
	Fig. 2

3. Turn the knob clockwise to tighten (Fig. 3).

CAUTION: Lock the release button in the primary hole and securely tighten the knob before operating this unit.

Knob

Fig. 3

CAUTION: The add-ons with the Click-Link® system are to be used in the primary hole unless stated otherwise in the specific add-ons operator’s manual. Using the wrong hole could lead to personal injury, or damage to the unit.

Check Flex Shaft Engagement Prior to Using

1.Start the unit.

2.Briefly engage and release the trigger.

3.Check that add-on is operating.

4.If the add-on is not operating, remove add-on and repeat steps for installing the add-on.

5.Recheck operation of add-on attachment.

6