ADJUSTMENTS

DANGER:

Laser radiation. Avoid direct eye contact with light source.

WARNING:

Use of controls or adjustments or performance of pro- cedures other than those specified herein may result in hazardous radiation exposure.

TO ADJUST THE LASER GUIDE

See Figure 37.

Use the work clamp or a C-clamp to secure a piece of scrap wood.

Plug the saw into the power source and make a slight cut to score the wood.

Release the switch trigger and allow the saw blade to stop rotating before raising the blade.

Raise the saw arm.

Unplug the saw.

To adjust the laser, loosen the laser adjustment screw using the Phillips end of the supplied blade wrench.

NOTE: When properly aligned, the laser should be on the left edge of the kerf.

Once aligned, tighten the screw then remove the blade wrench.

LASER

ADJUSTMENT

SCREW

Fig. 37

28

Page 28
Image 28
Ryobi TS1343L manual To Adjust the Laser Guide, Laser Adjustment Screw