ASSEMBLY
MITER SCALE
INDICATOR
SCREW
BLADE
SCALE
INDICATORBEVEL
SCALE
Fig. 22
SQUARING THE BLADE TO THE MITER TABLE
COMBINATION
SQUARE
MITER
TABLE MITER LOCK HANDLE
See Figures 22 - 25.
Unplug the saw.
Pull the saw arm all the way down and engage the lock pin to hold the saw arm in transport position.
Loosen the miter lock handle approximately
Depress the miter lock plate and rotate the miter table until the scale indicator on the control arm is positioned at 0°.
Release the miter lock plate and securely tighten the miter lock handle.
Loosen bevel lock knob and set saw arm at 0° bevel (blade set 90° to miter table). Tighten bevel lock knob.
Place a combination square against the miter table and the flat part of saw blade.
NOTE: Make sure that the square contacts the flat part of the saw blade, not the blade teeth.
Rotate the blade by hand and check the
The edge of the square and the saw blade should be parallel as shown in figure 23.
If the top or bottom of the saw blade angles away from the square as shown in figures 24 and 25, adjustments are needed.
Loosen bevel lock knob.
Adjust positive stop adjustment screw to bring saw blade into alignment with the square. See “Positive Stop Adjust- ment” in the Adjustment section.
Retighten bevel lock knob. Recheck
NOTE: The above procedure can be used to check blade squareness of the saw blade to the miter table at both 0° and 45° angles.
The saw has two scale indicators, one on the bevel scale and one on the miter scale. After squaring adjustments have been made, it may be necessary to loosen the indicator screws and reset them to zero.
BEVEL
LOCK
KNOB
CORRECT VIEW OF BLADE |
|
SQUARE WITH MITER TABLE | Fig. 23 |
BLADE
COMBINATION | MITER |
|
SQUARE | TABLE | MITER |
|
| LOCK HANDLE |
VIEW OF BLADE NOT SQUARE WITH MITER
TABLE, ADJUSTMENTS ARE REQUIRED
Fig. 24
BLADE
COMBINATION | MITER |
|
SQUARE | TABLE | MITER |
LOCK HANDLE
VIEW OF BLADE NOT SQUARE WITH MITER TABLE,
ADJUSTMENTS ARE REQUIRED | Fig. 25 |
|
19
