ASSEMBLY
TO INSTALL / REPLACE THE BLADE
See Figures 13 - 14.
WARNING:
A 10 in. blade is the maximum blade capacity of the saw. Never use a blade that is too thick to allow laser guide washer to engage with the flats on the spindle. Larger blades will come in contact with the blade guards, while thicker blades will prevent the blade bolt from secur- ing the blade on the spindle. Either of these situations could result in a serious accident and can cause serious personal injury.
Unplug the saw.
Raise saw arm.
Rotate lower blade guard up and remove blade bolt cover screw. Rotate blade bolt cover up and back to expose the blade bolt.
Depress the spindle lock button and rotate the blade bolt until the spindle locks.
Using the wrench provided, loosen and remove the blade bolt.
NOTE: The blade bolt has
Remove outer blade washer. Do not remove inner blade washer.
Wipe a drop of oil onto inner blade washer and outer blade washer where they contact the blade.
WARNING:
If inner blade washer has been removed, replace it before placing blade on spindle. Failure to do so could cause an accident since blade will not tighten properly.
Fit saw blade inside lower blade guard and onto spindle. The blade teeth point downward at the front of saw as shown in figure 14.
Replace outer blade washer. The double “D” flats on the blade washers align with the flats on the spindle.
Depress spindle lock button and replace blade bolt.
NOTE: The blade bolt has
CAUTION:
Always install the blade with the blade teeth and the arrow printed on the side of the blade pointing down at the front of the saw. The direction of blade rotation is also stamped with an arrow on the upper blade guard.
Tighten blade bolt securely.
Replace the lower blade guard and blade bolt cover.
Replace blade bolt cover screw and tighten securely.
SPINDLE
LOCK BUTTON
Fig. 13 |
NOTE: BEFORE USE, |
|
REPLACE SCREW AND | BLADE BOLT |
TIGHTEN SECURELY | COVER SCREW |
TO PREVENT GUARD |
|
MOVEMENT |
|
| LOWER |
| BLADE |
BLADE | GUARD |
BOLT |
|
COVER |
|
BLADE
OUTER BLADE
WASHER WITH
DOUBLE “D”
FLATS
TO
LOOSEN
TO | FLAT(S) |
ON SPINDLE | |
TIGHTEN |
|
BLADE BOLT |
|
(HEX. HD) |
|
INNER BLADE |
WASHER WITH |
DOUBLE “D” FLATS |
Fig. 14
16
