FEATURES
POSITIVE STOPS ON MITER TABLE
Positive stops have been provided at 0° , 15° ,
BEVEL LOCK KNOB
The bevel lock knob securely locks your compound miter saw at desired bevel angles. Positive stop adjustment screws have been provided on each side of the saw arm. These
adjustment screws are for making fine adjustments at 0° and 45° .
ELECTRIC BRAKE
An electric brake has been provided to quickly stop blade rotation after the switch is released.
MITER FENCE
The miter fence on your compound miter saw has been provided to hold your workpiece securely against when making all cuts; the left side is also larger providing additional support.
SELF-RETRACTING LOWER BLADE GUARD
The lower blade guard is made of
WARNING:
To avoid serious personal injury, always assure saw is fully supported and securely attached to a level work surface.
MOUNTING HOLES
See Figure 6.
Your compound miter saw should be mounted to a firm supporting surface such as a workbench. Four bolt holes have been provided in the saw base for this purpose. Each of the four mounting holes should be bolted securely using 3/8 in. (10 mm) machine bolts, lock washers, and hex nuts (not included). Bolts should be of sufficient length to accom- modate the saw base, lock washers, hex nuts, and the thickness of the workbench. Tighten all four bolts securely.
The hole pattern is for an 18 in. x 24 in. (457 mm x 610 mm) workbench. Carefully check the workbench after mounting to make sure that no movement can occur during use. If any tipping, sliding, or walking is noted, secure the workbench to the floor before operating.
ELECTRICAL CONNECTION
Your saw has a precision built electric motor. It should be connected to a power supply that is 120 volts, 60Hz, AC only (normal household current). Do not operate this tool on direct current (DC). A substantial voltage drop will cause a loss of power and the motor will overheat. If your tool does not operate when plugged into an outlet,
WARNING:
The operation of any saw can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before starting power tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We recommend wide vision safety mask for use over eyeglasses or standard safety glasses with side shields.
WARNING:
Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
TRACE HOLES
AT THESE LOCATIONS
FOR HOLE PATTERN
4 5
31.6 | 30 |
|
22.5 | 15 |
|
0
4 | 5 | 5 |
|
31.6
30
22.5
15
TRACE HOLES
AT THESE LOCATIONS
FOR HOLE PATTERN
MOUNTING SURFACE
SAW BASE
Fig. 6
Page 11
