ASSEMBLY
WARNING:
To prevent accidental starting that could cause possible serious personal injury, assemble all parts, make sure all adjustments are complete, and make sure all fasteners are secure before connecting saw to power supply. Saw should never be connected to power supply when you are assembling parts, making adjustments, installing or re- moving blades, or when not in use.
MITER LOCK HANDLE
See Figure 7.
To install the miter lock handle, place the threaded stud on the end of the miter lock handle into the threaded hole in the control arm under miter table. Turn clockwise to tighten.
DUST GUIDE
See Figure 8.
To install the dust guide, place the end over the exhaust port in the upper blade guard. Turn the guide so that the open end is facing down.
DUST BAG
See Figure 9.
A dust bag is provided for use on your miter saw. It fits over the exhaust port on the upper blade guard. To install it, remove dust guide from exhaust port. Then, squeeze the two metal clips to open the mouth of the bag and slide it on the exhaust port. Release the clips. The metal ring in the bag should lock in between the grooves on the exhaust port.
To remove the dust bag for emptying, simply reverse the above procedure.
WORK CLAMP
See Figure 10.
To install work clamp, place the shaft of the clamp in either hole in front of the miter table base. Rotate the knob on the clamp to move it in or out as needed.
WARNING:
When using the work clamp with the stop block, install the clamp on the stop block side of the blade. This will eliminate the possibility of the saw catching the loose end and kicking up. Failure to heed this warning can result in serious personal injury.
TO
LOOSEN | 1 |
|
0 |
| |
| 5 |
|
| 15 |
|
| 22.5 |
|
| 30 | 31.62 |
|
| 45 |
TO | CONTROL |
|
TIGHTEN | ARM |
|
MITER | MITER | |
LOCK HANDLE | TABLE | |
UPPER
BLADE GUARD
EXHAUST
PORT
DUST GUIDE
DUST BAG
EXHAUST
PORT
5 4
| 0 |
| 3 |
| .5 |
| 2 2 |
1 | 5 |
0
15
31.62 | 30 | 22.5 |
|
0 15 30
45
Fig.7
Fig. 8
Fig. 9
WORK CLAMP |
|
MITER |
|
TABLE BASE | Fig. 10 |
|
Page 12
