OIL AND FUEL INFORMATION
RECOMMENDED OIL TYPE
Using the proper type and weight of oil in the crankcase is extremely important. Check the oil before each use and change the oil
regularly. Failure to use the correct oil, or using dirty oil, can cause premature engine wear and failure.
Use a
ADDING OIL TO CRANKCASE – INITIAL USE
NOTE: This unit is shipped without being filled with oil. In order to avoid damage to the unit, put oil in the crankcase before attempting to start unit.
Your unit is supplied with one 3.4 fluid oz. (100 ml.) bottle of SAE 30 SF, SG, SH oil (Fig. 5).
NOTE: Save the bottle to measure the correct amount for future oil changes. See Changing the Oil Pg. 14.
1.Unscrew the top of the bottle of oil and remove the paper seal covering the opening. Replace top. Cut the tip off the funnel spout (Fig. 5).
2.Place the unit on a flat level surface with the cultivator in a horizontal position (Fig. 6).
3.Remove the oil plug / dipstick from the crankcase (Fig. 7).
4.Pour the entire bottle of oil into the oil fill hole (Fig. 8).
NOTE: Never add oil to the fuel or fuel tank.
5.Remove tag from oil fill plug / dipstick.
6.Wipe up any oil that may have spilled and reinstall the oil fill plug / dipstick.
The importance of checking and maintaining the proper oil level in the crankcase cannot be overemphasized. Check oil before each use and change as needed. See Changing the Oil Pg. 14.
Funnel Spout 
Fig. 5
Fuel Cap 
Fig. 6
Oil Fill Plug/Dipstick
Oil Fill Hole
Fig. 7
Oil Fill 
Fig. 8
RECOMMENDED FUEL TYPE
Old fuel is the primary reason for the unit not running properly. Be sure to use fresh, clean, unleaded Gasoline.
NOTE: This is a four cycle engine. In order to avoid damage to the unit, do not mix oil with Gasoline.
Definition of Blended Fuels
Today's fuels are often a blend of gasoline and oxygenates such as ethanol, methanol or MTBE (ether).
Using Blended Fuels
If you choose to use a blended fuel, or its use is unavoidable, follow recommended precautions.
•Always use fresh unleaded gasoline
•Use the fuel additive
•Drain tank and run the engine dry before storing unit.
9
