![](/images/backgrounds/100548/100548-968x1.png)
On some units, the
1.Place the
(4) Screws
Top Clamp
Middle Clamp
Bottom Clamp
Nuts
Fig. 1
2.While holding the three pieces together, install the four
(4) screws through the top clamp and into middle clamp.
NOTE: The holes in the top and middle clamp will line up only when assembled correctly.
3.Place the clamps and the
4.Hold each hex nut in the bottom clamp recess with a finger. Start screws with a large Phillips screwdriver. Do not tighten until you make the handle adjustment.
5.Slide the
Decal
Fig. 2
6.While holding the unit in the operating position (Fig. 3), position the
Fig. 3
7.Tighten the clamp screws evenly, until the
WARNING: Always use the shoulder harness when using the cutting blade to avoid serious personal injury.
1.Push the strap through the center of the buckle.
2.Pull the strap over the cross bar and down through the slot in the buckle (Fig. 4).
3.Put the harness on over head and onto shoulder. Snap it on to the support fitting (Fig. 5).
4.Adjust length to fit the operator’s size. Pull tab to lengthen, pull strap to shorten (Fig 6).
Fig. 4
Support Fitting
Fig. 5
Fig. 6
REMOVE AND INSTALL THE CUTTING ATTACHMENT SHIELDRemove the cutting attachment shield when using the unit as a brushcutter
WARNING: The cutting attachment shield should NOT be installed when operating the unit with a blade. Remove the cutting attachment shield before removing or installing the blade.
Remove the cutting attachment shield from the shield mount by removing the three (3) screws with a flat blade screwdriver (Fig. 7). Store parts for future use.
8