Saeco Coffee Makers Type SIN024X Troubleshooting, English, creamy froth forms on the surface

ENGLISH		Troubleshooting
Problem	Possible causes	Remedy
The machine does not turn on	The machine is not connected to the	Connect the machine to the
	power supply	power supply
The pump is very noisy	Water level in tank too low	Add water
		(section 4.4)
The coffee is too cold	The temperature ready light (5) was off	Wait until the light goes on
	when you pressed the switch (4)
	Filter holder not inserted for pre-	Pre-heat the filter holder
	heating (section 5).
The milk does not froth properly	Wrong kind of milk	Check the fat content
The coffee flows out too fast and no	Not enough coffee in the filter holder	Add some coffee (section 5)
creamy froth forms on the surface
	Coffee ground too coarsely	Use a different blend
		(section 6)
	Stale or unsuitable coffee.	Use a different blend
		(section 6).
No coffee flows out or it just drips	Water level in tank too low	Add water
out slowly		(section 4.4)
	Coffee ground too finely	Use a different blend
		(section 6)
	Coffee compressed too firmly in the	Loosen the ground coffee
	filter
	Too much coffee in the filter	Reduce the amount of
		coffee in the filter holder
	“Hot water/steam” knob (7) open.	Turn the knob (7) clockwise
		to close
	Excessive buildup of scale	Descale the machine
		(section 10)
	Filter in filter holder clogged	Clean the filter (section 9)
Coffee leaks outside the rim	Filter holder not properly fit into brew	Fit the filter holder properly
	unit	in place (section 5)
	Upper rim of filter holder dirty	Clean the filter holder rim
	Boiler gasket dirty or worn	Clean or replace gasket
	Too much coffee in the filter holder	Reduce the amount of
		coffee.
		Use the measure for the
		right amount.

Should any problems occur that are not included in the above table or cannot be re- solved using the remedies suggested contact an authorised service centre.

• 28 •