Safety 1st 4358-5721 Preparing to Install Rear-Facing, Preparing to Install Latch Rear-Facing

E-1 Preparing to Install Rear-Facing

5-40 lbs (2.3-18 kg) and 19-40 in. (48-101.6 cm) Rear-Facing using 5-point harness

LATCH Belt Lap/Shoulder Belt

Lap Belt

Never place a child rear-facing in a

seating position with an active frontal

airbag. This can result in serious injury or death.

This child restraint must always face the rear of the vehicle and be in the fully reclined position when the child is less than one year old.

E-2 Preparing to Install LATCH

Rear-Facing

1. Pull Pad Off Corners of

Child Restraint

Pull the pad off the front corners of plastic shell.

		2. Routing LATCH Belt
		Insert the hook with
		adjuster through the rear-
		facing belt path.
		Adjuster
		3. Pull Hook Across to
		Opposite Side
		Reach under pad and pull
1	2	the LATCH hook across the
		plastic shell. LATCH belt
		MUST be under pad and in
		front of buckle strap.
		NOTE: You must use the
		1st or 2nd buckle strap
		slots when rear-facing.
		4. Replace Pad Over
		Corners
		Make sure the LATCH
		belt is not twisted.

E. Installing Rear-Facing

37 38