Figure 1
Handle/Vent
Vent Slot Lid
Screw/Washer
Before First Use

1.Remove the Grill and any packaging materials.

2.Place the Base Frame on a flat, level surface.

3.Lift off the Side Trays and set them to the side. Disconnect the Storage Arms from the Wheel/Leg Frame to allow access to the Grill Assembly.

4.Remove the Grill Plate, Grill Base, Lid and Drip Tray. Wipe the Grill Base and Lid with a damp cloth to remove any dust. Wash the Grill Plate and Drip Tray in warm, soapy water. Rinse

and dry thoroughly.

5. The Handle/Vent and mounting hardware, (Screw/Washer) are

shipped in an inverted fashion, requiring minor assembly. Remove the Handle/Vent from the inside of the Lid by unscrew-

ing the Screw/Washer. Remove all parts, then properly position

the Handle/Vent on the top of the

Lid. Make sure the Handle/Vent stop pin enters the Vent slot in the Lid. From the inside of the Lid, place the Screw/Washer through the hole in the Lid and Handle/Vent. Securely fasten with a Phillips head screw driver. See Figure 1.

6.Slide the Drip Tray into the slots in the Grill Base.

7.See "Grilling Positions" on the following pages and place the Grill Base on the Base Frame.

8.Place the Grill Plate on the Grill Base and place the Lid over the Grill Plate.

Grill Positions

The Wheel-It and Grill-It™Portable

 

Propane Grill is compact enough to

 

transport to any grilling location.

 

Wheel-It from the storage shed to the

 

patio, to a picnic in the park, or off on

 

a camping trip. The Portable Propane

 

Grill easily transforms from storage to

 

transport and to high or low Grill-It

 

positions.

 

Storage Position: This position

 

makes the Grill compact enough for

 

space saving storage. The Side Trays

 

are stored on the Leg Assemblies and

 

the Transport Handle slides into the

 

top of the Frame.

Figure 2

 

7