Assembly Instructions

CAUTION: It is advisable that two persons assemble the grill. Never use the Storage Case/Stand as a chair. Never load anything on the Storage Case/Stand except the grill. Never load over 6 1/2 lbs. (3kg) on each Side Tray.

To transform the Grill from the

Rotate grill assembly onto the

Transport Position to the Grilling

Storage Case/Stand by sliding the

Position, lay the Storage Case/Stand on

Mounting Bracket under the lip in the

its side, unlatch, then remove the Base

front of the Storage Case/Stand.

Support Ring and Grill Body assembly.

 

 

Close and latch all 4 Latches of the

 

 

Storage Case/Stand. Turn the Storage

 

 

Case/Stand upside down and pull out

 

 

the Front Support Foot and the Support

 

 

Leg with wheels. Position the Base

 

 

Support Ring above the Front Support

 

 

Foot. Align and insert the tabs of the

 

 

Front Support Foot into the notches on

Mounting

 

the underside of the Base Support

 

Ring. Slide the notches on the opposing

Bracket

Push to

side of the Base Support ring under the

 

Lock

tabs on the Storage Case/Stand. Raise

 

 

 

the Securing Rod and snap it under the

 

 

metal clips on the Support Leg with

 

Drip

wheels. The other end of the Securing

 

Container

Rod will snap into the groove on the top

 

 

of the Base Support Ring and lock the

 

Drip Container

assemblies together. Turn the Storage

 

Holder

Case/Stand to the upright position. See

 

 

Figure 5.

 

Support

Place the grill assembly on top of the

 

Leg

Storage Case/Stand by sliding the

 

 

Mounting Bracket under the inside lip

 

 

of the Storage Case/Stand. Lift up the

 

 

Transport Handle/Drip Container Holder

 

 

to a level position. Insert the Drip

 

 

Container.

 

 

IMPORTANT: Push the Transport

 

Securing Rod

Handle/Drip Container Holder into the

 

 

 

slot of the Grill to lock it in place. This

 

 

is necessary as it keeps the Holder in

Front

Base Support

place and secures the back of the Grill

Support Foot

Ring

Assembly.

 

 

Raise the Cover and swing out both Side

 

Figure 5

Trays. IMPORTANT: Always unfold the

 

 

 

Side Trays before igniting, pre-heating or using the grill.

 

Attach the One Pound Propane Cylinder as instructed in 'Attaching Propane Gas Cylinder'. The Grill is ready for use.

Make sure the Drip Container is in proper position, and remember that the grill should always be operated with the Regulator on the right and the Drip Container in the rear.

9