HOW TO ASSEMBLE THE JUICER
1.Place the Stainless Steel Juice collector on the motor housing with the spout facing
the direction of the Locking Handle. Swivel until it locks into place. (See Ill. 1)
2.Place the Stainless Steel Strainer Basket inside the Juice Collector. Twist the Strainer Basket and gently push down until it is seated
in the Juice Collector. (See Ill. 2)
NOTE: The top edge of the Strainer Basket should not be higher than the edge of the Juice Collector when properly installed.
3.Place the Pulp Chute/Juicer Cover on the top so that the opening of the Pulp Chute is on the side opposite the spout. (See Ill. 3)
4.Lock the Pulp Chute/Juicer Cover into position by raising the Locking Bar until it clicks into the grooves located on both side of the Pulp Chute/Juicer Cover. (See Ill. 4)
NOTE: Push the Locking Bar until it is fully upright otherwise the Juicer will not operate.
5.Align the groove in the Food Pusher with the small protrusion on the inside of the Feed Tube.
6.Slide the Pulp Container into position under the Pulp Chute. Ensure that the Safety Foot
on the Pulp Container is fully inserted in the slot in the Motor Housing otherwise the Juicer
will not operate.
7.If the Froth Separator is not in the Juice Jug, slide between the tabs inside the Juice Jug. If you prefer to have juice with froth then the Froth Separator is not required.
8.Place the Juice Jug or a glass under the spout.
•
•
•
Ill.1
•
• 
•
Ill. 2
•
• 
•
Ill. 3
•
•
•
Ill. 4
5
