12
StudioDock 3i and 4i Rear Control Panel
The StudioDock 3i and 4i’s rear control panel is where you will make your connections
for the left side passive monitor, input signals and AC power. The following section
details the rear panel connections.
Powering the StudioDock 3i and 4i
Since the StudioDock 3i and 4i are active monitors with on-board power amplifiers, it is
necessary to connect the right side monitor to an AC power supply. Make sure that the
main Power switch is set to the off position and connect the supplied IEC power cable
into the AC inlet.
Things that go Hum!
When running power cables, be careful not to run the AC power cords or AC extension
cords in parallel to your input cables. This will help reduce any AC hum that can be
picked up. If your have to cross an AC line with an audio line, try to cross them at a 90
degree angle for the least amount of induced hum.
1. Power switch – The POWER switch
is used to turn on the StudioDock
3i and 4i’s active electronics.
When set to the on position, the
front panel blue LED illuminates,
indicating the StudioDock 3i and
4i are powered up and ready for
operation.
2. AC Inlet - Connect the supplied IEC
power cable here.
3. Voltage switch - The slide switch
is used to select the operating
voltage. NOTE: Be sure that the
switch is set to the correct voltage
for your country.
The Ins and The Outs
The StudioDock 3i and 4i features
a stereo pair of input connectors
providing easy installation with a
variety of audio devices like recording
consoles, hard disk recorders, CD players
Operating the StudioDock 3i and 4i
ENGLISH