Setting Up and Using the
UHF Synth System
used at the same location, all devices must be set to the same Group (though each will use its own Channel) or intermodulation noise may occur. If you are using the
7.Turn on the power to the UT-5 or UH-5 transmitter (using its Power on-off switch) and observe the RF Level display in the UR-5 or UR-5D receiver; all segments should light up. When first setting up the UHF Synth System in a new environment, it’s always a good idea to do a walkaround while experimenting with different Group and Channel settings—you may find that some cause more RF Level segments to light up than others (the more segments light, the stronger the signal). Always pick the Group that has the greatest number of clear Channels and the Channel providing the strongest signal. Note that whenever a new channel is selected, it takes approximately five seconds for audio signal to be passed through to the receiver outputs.
8.Once you’ve settled on your Group and Channel assignments, it’s time to set the audio levels. If you are using the
*If your installation requires more than seven simultaneous Channels, you’ll have to use Group 9.
18