Setting Up and Using the DA-5L
The basic procedure for setting up and using your DA-5L UHF Antenna Distribution Amplifier takes only a few minutes:
1.Remove all packing materials (save them in case of need for future service) and mount the DA-5L into your rack. Turn off the power to your audio system and all wireless components.
2.Mount a tuned coaxial antenna from your UHF receiver* into the DA-5L front-
panel “Antenna-A” input by inserting it into the BNC connector (this connector is “keyed” so that you may have to rotate the antenna slightly until it drops all the way down into the seating). Then twist the outer ring of the antenna clockwise until it clicks into place. Repeat the same proce- dure in order to mount the other antenna into the front-panel “Antenna-B” input. Note that both antenna inputs are phantom powered; take care not to short them.
3.Using the supplied BNC connectors, make a connection between the rear-panel Antenna Output 1 (Distributor A) and the “Antenna A” input of the first UHF receiver in your system. Then make a connection between the rear-panel Antenna Output 1 (Distributor B) and the “Antenna B” input of the first UHF receiver in your system. Repeat this procedure as necessary to connect the other DA-5L Antenna Outputs to the “Antenna A” and “Antenna B” inputs of up to three additional receivers.
ANTENNA OUTPUT 50 Ω
DISTRIBUTOR A
* Third-party antennas should not be substituted.
