Samson X15D, X12D owner manual Quick Start

Quick Start

1.Turn the Level control on the rear panel fully counterclockwise.

2.Set the HPF and EQ switches to the Flat positions (figure 1).

3.Turn the Power switch OFF.

4.Connect either a line level signal from your mixer (or other audio source) or a microphone to the Input 1 jack or a line level signal to the Input 2 jack on the Auro X12D/X15D rear panel (figure 2). If using a microphone, set the Mic/Line Switch to the microphone position.

5.Connect the supplied power cable to the AC Power Inlet on the back of the loudspeaker. Plug the power cable into an AC outlet (figure 4).

Note: Always make sure that the AC outlet is configured with the correct voltage as indicated on the rear panel of the Auro loudspeaker.

6.Switch the Auro’s Power switch to the ON position.

7.Run an audio signal from your mixer, or talk into the microphone (figure 4).

8.Slowly raise the Auro’s Level control until you have reached the desired level.

9.If the volume from the speakers gets really loud, or you see the Peak indicator blinking frequently, turn down the Level control

on the Auro X12D/X15D a little until the Peak indicator does not light, or only lights occasionally with signal peaks.

figure 1

figure 2

figure 3

figure 4

8