Connecting the FM and AM(MW/LW) Antennas
1 | 2 | 3 | If AM reception is |
|
|
| poor, connect an |
|
|
| outdoor AM |
GB |
|
| antenna(not |
|
|
| supplied). |
AM Loop Antenna
(supplied)
ANTENNA
If FM reception is poor,
connect outdoor FM antenna
(not supplied).
FM Antenna (supplied) | Snap the tabs on the loop into the |
| slots of the base to assemble the |
| AM loop antenna. |
WOOFER | CENTER | ||
|
|
| IMPEDANCE |
Cooling fan (See “About Cooling Fan” below.)
AUX Connections
GB
External Digital
Components
For connection to external equipment with digital output.
Example: CD recorders, MD (Mini Disc) D/A converters or other components equipped with digital output jacks
DIGITAL OUT
Optical Cable |
Video Cable |
IMPEDANCE |
Audio Cable (Red/White)
If the external analog |
component has only one |
output jack, you may |
connect either L or R. |
External Analog |
FM antenna connection
1.Connect the FM antenna supplied to the FM 75Ω
COAXIAL terminal.
2.Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a wall or other rigid surface.
•If reception is poor, connect an outdoor antenna. Before attaching a 75Ω coaxial cable (with a standard type connector), disconnect the supplied FM antenna.
(About the cooling fan)
A cooling fan is mounted on the rear panel of the center unit to prevent abnormal temperature inside the center unit, thus assuring normal operation. The cooling fan automatically starts rotating to supply external cool air to the inside of the center unit when the internal temperature exceeds the specified limit.
AM(MW) antenna connection
1.Connect the AM loop antenna supplied
to the AM and terminals.
2.If reception is poor, connect an outdoor single
For safety, observe the following carefully.
•Make sure there is good ventilation around the center unit. Poor ventilation could overheat and damage the canter unit.
•DO NOT block the cooling fan and the ventilation openings or holes. (If they are blocked by a newspaper or cloth, etc., the heat may not be able to escape.)
| Components |
|
|
| R | L |
|
| Connect to external equipment with | • Always connect the video and | |
| analog output. |
| audio connection cables to the |
| Example: Video, TV, LDP, etc. | equivalent colored jack. | |
| Making Analog Input Selection |
| |
Remote Control | Press the AUX button and select AUX1 IN, AUX2 IN. |
| |
Main Unit | Press the Function button and select AUX1 IN, AUX2 IN. |
|
11 | 12 |