GBGB
3433

Speaker Setup

To set up Speaker Balance

1Use the Left/Right ( / ) button to raise or
lower the output level of the chosen
speaker(s).
Example: 5.1CH Sound Setup
Sound Edit
Subwoofer
Center Speaker
Rear Speaker
++
+
Press the Sound Editbutton.

Each time the button is pressed the selection switches

as shown below.
2
The display changes depending on the current audio output
mode (DSP, PRO LOGIC, 3-STEREO, STEREO, etc.).
While in DSP or PRO LOGIC mode, TEST TONE may
operate differently for VCDs or CDs.

Speaker Setting Methods

The test signal will be sent to the Left Front, Center, Right Front,

Right Rear, Left Rear in that order.
Test Tone
Press the Test Tone button.
To End the Speaker Setup
Test Tone

Press the Test Tone button again.

L
LS RS
CR
LCR
LS
LFE
RS
D I G I T A L
LCR
LS
LFE
RS
D I G I T A L
LCR
LS
LFE
SRS
D I G I T A L
LCR
LS
LFE
RS
D I G I T A L
LCR
LS
LFE
RS
D I G I T A L
OFF, range of 6 ~ 0
OFF, range of 6 ~ 0
range of 6 ~ 00 ~ +6
range of 6 ~ 00 ~ +6
range of 6 ~ 00 ~ +6
Front Speakers: L level, R level
Rear Speakers: L level, R level
Center Speaker
Rear Speakers
Subwoofer Speaker

You can adjust various settings by using their

corresponding buttons on the remote control unit.

Selecting Dolby Pro Logic

Converts Dolby Surround encoded 2-channel sound (e.g., program material received by Stereo
VCR could be Dolby Surround encoded 2-channel material that can be decoded into 4-channel
sound using the Dolby Pro Logic mode). Pro Logic mode can also be enjoyed when in DVD
mode or when playing Dolby Digital or PCM material that is Dolby Surround encoded.
Pro Logic
Press the Pro Logic button.

12

Press the Function Selection button to
select the desired function.
Press the Pro Logicbutton.

Select from FM, AM, DVD and AUX IN.

Each time the Pro Logic button is pressed

S
C
S
PRO LOGIC
PRO LOGIC
LS RS
C
LFE
S
LS RS
C
LFE
LS RS
LFE
PRO LOGIC :Left, Center, Right, Subwoofer and
Surround Channel
3-STEREO : Left, Center, Right and Subwoofer
Channel
STEREO : Left, Right and Subwoofer Channel