GBGB
FM antenna connection
1. Connect the FM antenna supplied to the FM 75Ω
COAXIAL terminal.
2. Slowly move the antenna wire around until you
find a location where reception is good, then
fasten it to a wall or other rigid surface.
•
If reception is poor, connect an outdoor antenna.
Before attaching a 75Ωcoaxial cable (with a standard
type connector), disconnect the supplied FM antenna.
AM/MW antenna connection
1. Connect the AM loop antenna supplied
to the AM and terminals.
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected).
12

Connecting the FM and AM

(

MW/LW

)

Antennas

11
A cooling fan is mounted on the rear panel of the center unit to
prevent abnormal temperature inside the center unit, thus assuring
normal operation. The cooling fan automatically starts rotating to
supply external cool air to the inside of the center unit when the
internal temperature exceeds the specified limit.
For safety, observe the following carefully.
• Make sure there is good ventilation around the center unit. Poor
ventilation could overheat and damage the canter unit.
• DO NOT block the cooling fan and the ventilation openings or
holes. (If they are blocked by a newspaper or cloth, etc., the heat
may not be able to escape.)
(About the cooling fan)

AUX Connections

Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.
Cooling fan (See “About Cooling Fan” below.)
VIDEO ANTENNA
S-VIDEO
ANTENNA
123
If FM reception is poor,
connect outdoor FM antenna
(not supplied).
FM Antenna (supplied)
AM Loop Antenna
(supplied)
If AM reception is
poor, connect an
outdoor AM
antenna(not
supplied).
VIDEO ANTENNA
S-VIDEO
VIDEO IN
TV
External Analog
Components
Audio Cable (Red/White)
To view pictures from the
external input (AUX),
first connect the VIDEO
IN jack (VIDEO) and then
connect the VIDEO OUT
jack.
Connect to external equipment with
analog outputs.
Example: Video, TV, etc.

• Always connect the video and

audio connection cables to the
equivalent colored jack.
Press the AUX button and select AUX IN.
Making Analog Input Selection
Press the Function button and select AUX IN.
Remote Control
Main Unit
If the external analog
component has only one
output jack, you may
connect either L or R.