*This drawing is provided for illustration purposes only and the actual appearance of the items depicted may vary.
Auto Sound Calibration
Microphone
L: Front Speaker (L) | R: Front Speaker (R) |
C: Center Speaker | SW: Subwoofer |
LS: Rear Speaker (L) | RS: Rear Speaker (R) |
To select the RRSS that you have set
Briefly press the RRSS button.
(If you have set the RRSS for the first time according to
Steps 1 to 3 on the previous page)
•Your selection will toggle between "REAR REFLECTING ON" and "REAR REFLECTING OFF" on the display.
•Select "REAR REFLECTING ON" to listen using the RRSS setting and select "REAR REFLECTING OFF" to listen to the disc currently being played in its original setting.
To enable or disable the sound logo
When you turn on the power, a sound logo will be heard, indicating that the disc reading is completed and the player is in its optimal condition to play the disc.
1.Press and hold the RRSS button.
•"S.LOGO ON" or "S.LOGO OFF" appears on the display.2.Briefly press the RRSS button.
•Each time you press the button, your selection toggles between "S.LOGO ON" and "S.LOGO OFF".
•Select "S.LOGO ON" to enable the sound logo and select "S.LOGO OFF" to disable the sound logo.
SETUP
To check the RRSS that you have set
1.Press and hold the RRSS button twice.
•"CHECK" appears on the display.
2.Next,briefly press the RRSS button.
•The speaker distance and level value for each channel will be displayed.
To cancel the RRSS setup
Press the RRSS button.
Caution 
•If the system is installed at a location where sound cannot be reflected (e.g., an open space without walls), the speaker distance, channel level, and rear sound reflection effect may be set incorrectly during the RRSS setup.
• The tone output stops, "CANCEL" appears on the display, followed by "REMOVE MIC", and then the
| setup will be cancelled. | 62 |
|
