Samsung 451 user manual Installing Batteries in the Remote Control, Antennas with 300 win Leads

Installing Batteries in the Remote Control

1.Lift the cover at the back of the remote control upward as shown in the figure.

2.Install two AAA size batteries.

Make sure to match the "+" and "–" ends of the batteries with the diagram inside the compartment.

3.Replace the cover.

Remove the batteries and store them in a cool, dry place if you won’t be using the remote control for a long time.

The remote control can be used up to about 23 feet from the TV. (Assuming typical TV usage, the batteries should last for about one year.)

If the remote control doesn’t work, check the following:

1.Is the TV power on?

2.Are the plus and minus ends of the batteries reversed?

3.Are the batteries drained?

4.Is there a power outage or is the power cord unplugged?

5.Is there a special fluorescent light or neon sign nearby?

Connections

Connecting VHF and UHF Antennas

If your antenna has a set of leads that look like the diagram to the right, see "Antennas with 300 Twin Leads" below.

If your antenna has one lead that looks like the diagram to the right, see "Antennas with 75

If you have two antennas, see "Separate VHF and UHF Antennas".

Antennas with 300 win Leads

If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has 300 below.

1.Place the wires from the twin leads under the screws on a 300-75 (not supplied).

Use a screwdriver to tighten the screws.

2.Plug the adaptor into the ANT IN terminal on the back of the TV.

Antennas with 75

1.Plug the antenna lead into the ANT IN terminal on the back of the TV.

ons

ANT IN

ANT IN

Separate VHF and UHF Antennas

If you have two separate antennas for your TV (one VHF and one UHF), you must combine the two antenna signals before connecting the antennas to the TV. This procedure requires an optional combiner-adaptor (available at most electronics shops).

1. Connect both antenna leads to the combiner.

UHF

VHF

2.Plug the combiner into the ANT IN terminal on the bottom of the rear panel.

ANT IN

UHF

VHF

English - 6