65
Setting up the printer
Chapter 1
1-3. Connecting the cables
Plugging in AC adapter
Connect the AC adapter according to the following procedure.
1) Make sure the printer is turned off.
2) Plug the AC adapter cable into the printer’s power connector.
3) Plug the power cord into the outlet, and turn on the power.
Connect the printer to the host ECR (host computer) though an
interface cable matching the specification of the printer and the host
ECR (host computer).
Be sure to use a drawer that matches the printer’s specification.
Depending on the interface your system uses, either connect
the serial, parallel or USB communication cable to the appropriate
connector on the back of the printer.
Cable are provided by your dealer or system installer.
Before connecting the printer to the power supply, make sure that the voltage and power
specifications match the printer’s requirements.
Using an incorrect power supply can cause serious damage to the printer.
CAUTION
Connecting the interface cable
1)Turn off printer and the ECR (host computer) host.
2)Plug the interface cable into the interface connector on the printer
then fasten the screw on both sides of the connector.
3)Plug the drawer kick-out cable into the drawer Kick-out connector
on the printer. (When removing the drawer kick-out cable,
press in on the connector’s clip and pulling out.)
Connect the interface cable according to the following procedure.
Drawer kick-out
Connector
Power
connector
Interface
connector
Serial/Parallel/USB
Interface cable
Drawer kick-out
cable Power cord
AC adapter