Printer Options 6-7
5. Make sure both metal clips on the connector are fastened and the
two pins on the connector are pushed through the holes on the
memory option.
6. If you need to install another option on the control board:

Note: After you complete installing, you have to set the Printer

Memory item on the Printer Properties dialog box to the

upgraded value. To access the Properties dialog box, see page 4-8.

Removing a Memory Option
1. If necessary, follow the steps under ‘Accessing the Printer Control
Board’ on page 6-2.
2. Locate the memory option you want to remove.
3. Push out on the metal clips at each end of the connector ( ) and
rotate the memory option up to a 30oangle ( ) . Pull it out of the
connector ( ) .
Pin
Clip
1
1
2
3
2
1
2
3