User’s Manual 14
Setup
1.Turn off your computer and unplug the power cord.
2.Connect the end of the signal cable to your computer's video port (video board, video card or graphics card).
3.Connect one end of a sound cable to the Stereo Output jack on your sound card or computer.Connect the other end of the cable to the Stereo Input jack on the back of the monitor stand.Connect one end of the other sound cable to the Mic Input jack on your sound card or computer.Connect the other end of this cable to the Mic
4.Plug the DC power cord from the stand into a nearby outlet.5. Connect the power cord for your monitor to the power port on the back of the monitor.
6.Plug the power cord for the monitor and the power cord for your computer into a nearby outlet. 7.Turn on your computer and monitor. If your monitor displays an image,video installation is
complete.
8.Turn up or down the
volume by turning up or down until the sound volume is appropriate. 10. Adjust the treble and bass.
Note Sound distortion may occur when the monitor is placed on top of a mostly hollow cabinet such as your computer. If this occurs, place a pad or magazine beneath the monitor stand. High sound volume may also cause sound distortion;
lower the volume.
3. Multimedia Speaker Stand | 1.Mic | |
|
| To transmit your voice,connect a sound cable from |
|
| the Mic |
|
| slot in your computer. |
|
| 2.Stereo Input Jack |
|
| Connect a sound cable from the input source |
|
| (sound |
|
| 3.DC power Cord |
|
| Connect DC power cord to monitor DC 12V output jack. |
|
| 4.Power Indicator |
|
| Glows green when the speakers are turned on. |
|
| 5.On/Off Volume |
|
| Turns On/Off and adjusts the output volume. |
|
| 6.Treble Control |
|
| Use to control high frequencies. |
|
| 7.Bass Control |
|
| Use to control low frequencies. |
|
| 8.Mic Input Jack |
|
| To transmit your voice,connect a microphone to this jack. |
|
| 9.Headphone Jack |
|
| To listen in privacy,connect headphones here. |
|
| 10.Detachable Stand Top |
|
|
|
