Operating your sound system - FM auto-tune

1.Fully extend the telescopic aerial.

2.Press the On / Standby button to switch on your sound system.

3.Press the DAB/FM button to select the FM band.

4.Press and release the Auto-tune button to cause your radio to scan in the direction previously scanned and stop automatically when it fi nds a station of suffi cient strength.

5.After a few seconds the display will update. The display will show the frequency of the signal found. If the signal is strong enough and there is RDS data present then the radio will display the station name. After ten seconds the display will revert to showing the time and day.

6.To fi nd additional stations press and release the Auto-tune button as before.

7.To scan the FM band in a opposite direction rotate the Tuning control clockwise (to scan low frequency to high frequency) or anti-clockwise (to scan high frequency to low frequency) and then press the Auto- tune button again.

8.When the end of the waveband is reached your radio will recommence tuning from the opposite end of the waveband.

9.Adjust the Volume to the required setting.

10.To switch off your sound system press the On / Standby button.

If you need any further advice, please call our Technical Helpline on :-

2,10

3

4-7

7

If you fi nd that an FM broadcast has a lot of background hiss, this may often be reduced by setting the radio into Mono reception mode for the current FM station. Please refer to the section "Stereo / Mono setting - FM" on page 27 for further details.

020 8758 0338 (Mon-Fri)

12