Cooling Your Room
You must select the Cool mode if you wish to adjust the:
◆Cooling temperature
◆Fan speed when cooling
1If necessary, press the 
(On/Off) button.
Result: ◆ The air conditioner starts up in Cool mode with
Turbo fan speed.
◆The operation indicator on the indoor unit lights up.
◆The indoor unit beeps.
IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:
◆Plugged in
◆Stopped
lt will start up normally after three minutes.
2If the 
is not displayed at the top of the remote control,
press the 
button on the remote control one or more times until it appears.
Result: ◆ The indoor unit beeps each time you press the 
button.
◆The air conditioner runs in COOL mode.
Note You can change modes at any time.
3To adjust the temperature, press the 
button one or more times until the required temperature is displayed.
Possible temperatures are between 18°C and 30°C inclusive.
Result: ◆ Each time you press the 
button:
-The temperature is adjusted by 1°C
-The indoor unit beeps
◆The air conditioner starts cooling, provided that the room temperature is higher than the selected temperature.
◆If the room temperature reaches the set temperature, the air conditioner stops cooling, but the fan is still operating.
4Select the fan speed by pressing the 
button one or more times until the required setting is displayed:
Automatic (rotated : 
)
Low
Medium
High
Turbo (maximum)
Result: Each time you press the 
button, the indoor unit beeps.
5To control the direction of the air flow, refer to pages 16 and 17.
Note ◆ If you turn off the air conditioner in Cool mode, the set temperature is adjusted as below when you turn on the air conditioner again.
Previous set temperature | Set temperature |
Over 24°C | 24°C |
Below 24°C | Previous set temperature |
|
|
