Test Tone

Use test tone to check speaker connection status or defect of speaker or adjust the level.

To Automatically Output Test Tone

√

MAIN UNIT

1 Press and hold SURROUND button for about 5 seconds.

•“SETUP MODE” appears on the display and enters into Setup Mode.

2 Press INPUT button 4 times.

•“TEST-T AUTO” appears in the display.

3 Press SURROUND button.

•Test signal will be automatically output as follows; F.L ➝ CEN ➝ F.R ➝ S.R ➝ S.B

➝ S.L ➝ S.W .

• During test signal output, press SELECT ( , ) button to adjust the speaker output level from -10 to +10 dB by 1 step.

To Stop Test Tone

Method 1) Press INPUT button 2 times.

•“TEST-T OFF” appears on the display and test tone stops.

Method 2) Turn VOLUME CONTROL.

•“SETUP MODE OFF” appears on the display and test tone stops.

23

Test Tone Output•F.L (Front-Left) :-10 ~ +10dB•CEN (Center) : -10 ~ +10dB•F.R (Front-Right) :-10 ~ +10dB•S.R (Rear-Right) :-10 ~ +10dB•S.B (Rear Center): -10 ~ +10dB•S.L (Rear-Left):-10 ~ +10dB•S.W (Subwoofer): -10 ~ +10dB

To Manually Output Test Tone

√

1 Press and hold SURROUND button for about 5 seconds.

OPERATION

MAIN UNIT

 

•“SETUP MODE” appears on the display and enters into Setup Mode.

2 Press INPUT button 5 times.

•“TEST-T MANU” appears in the display.

3 Press SURROUND button.

•Each time you press this button, F.L ➝ CEN ➝ F.R ➝ S.R ➝ S.B ➝ S.L ➝ S.W will be selected in turn.

4 Press SELECT( ,)button to set the test tone as you want.

•You can adjust the speaker output level from -10 to +10dB by 1 step.

To Stop Test Tone

Method 1) Press INPUT button 1 time.

•“TEST-T OFF” appears on the display and test signal stops.

Method 2) Turn VOLUME CONTROL.

•“SETUP MODE OFF” appears on the display and test tone stops.

Caution!

•You cannot use test tone in 5.1CH MULTI CH function.

24