Cooling Your Room
Remote Control | Control Panel | You must select the Cool mode if you wish to lower the temperature |
in your room. You can also set the fan speed. |
1Press the 
(On/Off) button.
Result: ◆ The air conditioner starts up in the mode selected when the unit was last used.
◆ The unit beeps twice.
☛The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:
◆Plugged in
◆Stopped
It will start up normally after three minutes.
2If the COOL indicator is not lit on the unit:
◆ Press the COOL button on the remote control or
◆ Press the Mode button on the unit one or more times until the COOL indicator lights up
Result: ◆ The unit beeps each time you press the COOL/Mode button. ◆ The air conditioner starts up in the Cool mode.
➢ | You can change modes at any time. |
3 To adjust the temperature, press the Temperature buttons on the remote control or unit one or more times until the desired temperature is displayed.
The temperature can be set between 64°F and 86°F. Result: ◆ Each time you press the temperature buttons:
– The temperature is adjusted by 1°F and displayed on the control panel
– The unit beeps
◆The air conditioner starts cooling if the room temperature is higher than the selected temperature.
4 To set the fan speed:
◆ Press the HIGH, MED or LOW button on the remote control as desired. or
◆Press the Fan Speed button on the unit one or more times until the
desired Fan speed indicator lights up.
5To control the direction of the air flow, refer to page 10.
