SETTING
On start
When this function is “On,” projector is automatically turned on just by connecting AC Power cord to a wall outlet.
Note ; Be sure to turn projector off properly (refer to section “TURNING OFF PROJECTOR” on P19). If projector is turned off in wrong steps, On Start function does not operate properly.
Remote control
This projector has two different remote control codes;
When operating projector in “Code 2,” both projector and Remote Control Unit must be switched to “Code 2.”
To change code of Projector;
Set Remote control in SETTING MENU to “Code 2.”
To change code of Remote Control Unit;
Press both MENU and IMAGE buttons on Remote Control Unit together for over 10 seconds.
After changing code, make sure Remote Control operates properly. To return to normal code (Code 1), operate both projector and Remote Control in ways above again.
PJ-Net Organizer
This function cannot be adjusted when not attach the
Refer to the owner's manual in the optional
On start
On
Code 1
Press SELECT button at this icon to display other items.
Press SELECT button at this icon to display previous items.
Move pointer to item and then press POINT LEFT/RIGHT button(s).
Lamp counter reset
This function is used to reset Lamp Replace Counter. When replacing Projection Lamp, reset Lamp Replace Counter by using this function. Refer to page 40 for operation.
Quit
Closes SETTING MENU.
Lamp
counter reset
On
Code 1
Move pointer to Lamp counter reset and then press SELECT button. Message “Lamp replace counter reset?” is displayed.
38
