Installation of the Drain Tube

Fix the drain tube as shown in the figure.

Installation of the Drain Pan

The procedure for installing the drain pan should be determined by the condition of the installing area.

◆In the case of an area where the drain pan can not be directly installed on the rear side of the unit after installing the air conditioner.

Example: High storage

1Hold the handle of the air filter, pull it slightly forward, and then pull it out to the right side.

2Remove the screw.

3Disassemble the front grille.

3-1 Hold the lower part of the front grille, and then move it slightly to the left side.

3-2 Pull the lower part of the front grille slightly forward.(below three inches) 3-3 Lift the front grille upward.

☛Applying excessive force to disassemble the front grille may cause damage to the tab ; be sure not to use excessive force.

4Remove two screws on the lower, right and left sides of the unit.

5Remove the chassis from the cabinet.

6Remove the rubber cap inserted into the basepan.

7Fix the drain pan as shown in the figure, and then connect the drain hose. (You can use any commercially-available drain hose.)

8Install the cabinet at the specified area after installing the drain pan, and then re-assemble it in the original condition.

◆In the case of an area where the drain pan can be directly installed on the rear side of the unit after installing the air conditioner.

1Follow steps 6 and 7 only

Rear

Rubber cap

Gasket

Drain Tube

Screws(2EA)

Screw

Front grille

E-13