Removing Excess Humidity
Remote Control | Control Panel |
Dry
If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much.
1If necessary, press the 
(On/Off) button.
Result: 
The air conditioner starts up in the Cool mode. 
The unit beeps.
The air conditioner is fitted with a protection mechanism to pre- vent the unit from being damaged when it is started immediately after being:
Plugged in
Stopped
It will start up normally after three minutes.
2If the humiduty indicator is not displayed at the top of the control panel, press
the 
button on the control panel one or more times until it appears.
Result: | The unit beeps each time you press the | button. |
| The air conditioner runs in Dry mode. |
|
You can change modes at any time.
3 To adjust the temperature, press the or buttons one or more times until the required temperature is displayed.
Possible temperatures are between 18°C and 30°C inclusive.
Result: | Each time you press the | or | buttons: |
-The temperature is adjusted by 1°C
-The unit beeps
The air conditioner starts removing the excess humidity; the quality of air is adjusted automatically.
4To control the direction of the air flow, refer to page 11.
