Setting the Time |
| Checking that Your Oven is Operating Correctly |
EN
Your microwave oven has an inbuilt clock. The time can be displayed the only
•When you first install your microwave oven
•After a power failure
✉Do not forget to reset the clock when you switch to and from summer or winter time.
1.Turn the Jog Dial to set the hour.
Next : Press the blinking button.
2.Press the start( 
) button.
Next : Turn the blinking dial.
3.Turn the Jog Dial to set the minute.
Next : Press the blinking button.
4.When the right time is dispeayed, press the start( 
) button.
Result: The time is displayed whenever you are not using the microwave oven.
The following simple procedure enables you to check that your oven is working correctly at all times. If you are in doubt, refer to the section entitled “What to Do if You are in Doubt or Have a Problem” next the page.
✉The oven must be plugged into an appropriate wall socket. The turntable must be in position in the oven. If a power level other than the maximum (100% - 900 W) is used, the water takes longer to boil.
Open the oven door by pulling the handle on the right side of the door. Place a glass of water on the turntable. Close the door.
Press the start( 
) button and set the time to 4 or 5 minutes,
by pressing the start( 
) button the appropriate number of times.
Result: The oven heats the water for 4 or 5 minutes.
The water should then be boiling.
8
