Connecting Your Monitor

4. Connecting a Camcorder

1.Locate the A/V output jacks on the camcorder. They are usually found on the side or back of the camcorder.

Connect a set of audio cables between the AUDIO OUTPUT jacks on the camcorder and the CVBS, S-Video Audio Connection Terminal on the Monitor.

2.Connect a video cable between the VIDEO OUTPUT jack on the camcorder and the CVBS Video Connection Terminal on the Monitor.

3.Select Video 1 that is connected to a Camcorder using the Source button on the monitor's front or remote control.

4.Then, start the Camcorders with a tape inserted.

The audio-video cables shown here are usually included with a Camcorder. (If not, check your local electronics store.) If your camcorder is stereo, you need to connect a set of two cables.

5. Connecting DTV Set Top Box

The connections for a typical Set Top Box are shown below.

1.Connect a set of audio cables between the Component Audio Connection Terminal on the Monitor and the AUDIO OUT jacks on the Set Top Box.

2.Connect a BNC cable between the RGB 3 (COMPONENT VIDEO) IN terminal - Pb, Y, Pr port on the Monitor and the Pb, Y, Pr jacks on the Set Top Box.

3.Select BNC that is connected to a DTV Set Top Box using the Source button on the monitor's front or remote control.

For an explanation of Component video, see your Set Top Box owner's manual.