Chapter Two

IN S TA L L AT I O N

Connecting VHF and UHF Antennas

If your antenna has a set of leads that look like this, see “Antennas with 300-ohm Flat Twin Leads” below.

If your antenna has one lead that looks like this, see “Antennas with 75-ohm Round Leads” on next page.

If you have two antennas, see “Separate

VHF and UHF Antennas” on next page.

Antennas with 300-ohm Flat Twin Leads

If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has 300-ohm twin flat leads, follow the directions below.

1

Place the wires from the twin leads under the screws on the 300-75 ohm adaptor (not supplied). Use a screwdriver to tighten the screws.

2

Plug the adaptor into the VHF/UHF terminal on the bottom of the back panel.

11