Operation
Reading each Memory Program’s Cycle Counter
1 Press the Check button.
The display will be cleared.
2 Press the Start button, then any Number button, from 1 to 20. The
number of cycles for that particular Memory Program will be displayed. The cycle count is displayed in units of 10. For example, if Memory Program 5 has been used 100 times, the display will show “10”.
As the display uses units of 10, the cycle counts are approximate. The cycle count displayed increases every ten cycles. For example, if the cycle count were
3 After one second, the display will clear automatically. If you want to check the cycle count of other Memory Programs, just enter the Memory Program numbers.
4 Press the Stop/Clear button to exit the Checking mode.
Resetting the Memory Program Cycle Counter
1 Clear all operations by pressing the Stop/Clear button.
The display will show “ : 0 “ or the present time (If the time is set).
2 Press Number “0 “ and theAuto Defrost button at the same time.
The Microwave will emit a Beep sound confirming the reset
operation. The display will show “ : 0 “ or the present time (If the time is set).
Setting the Sound
1 Press the Sound button to adjust sound volume. The basic sound volume is "LO". Press the Sound button repeatedly, to change the volume in the following order - MED, HI, OFF, LO.
Indicator | Sound | |
|
|
|
HI | Loud | |
|
|
|
MED | Middle | |
|
|
|
LO | Low | |
|
|
|
Blank | Off | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2 Press the Start button to exit the Sound mode.
The display will show “ : 0 ” or the present time (If the time is set).
12