10
REFRIGERATOR INSTALLATION
WARNING
UNPACKING YOUR REFRIGERATOR
Remove tape and any temporary labels from the
refrigerator before using. Do not remove any warning-
type labels, the model and serial number label, or the
tech sheet that is attached to the back wall of the
refrigerator.
To remove any remaining tape or glue, rub the area briskly
with your thumb. Tape or glue residue can also be easily
removed by rubbing a small amount of liquid dish soap
overtheadhesivewithyourngers.Wipewithwarmwater
and dry.
Donotusesharpinstruments,rubbingalcohol,ammable
uids,orabrasivecleanserstoremovetapeorglue.These
products can damage the surface of the refrigerator. For
more information, see the Important Safety Instructions
section.
Refrigerator shelves are installed in the shipping position.
Please reinstall the shelves according to your individual
storage needs.
•Toreducetheriskofelectricshock,donotinstall
the refrigerator in a wet or damp area.
•Selectaplacewhereawatersupplycanbeeasily
connected for the automatic icemaker.
REQUIRED TOOLS
The following tools are needed to install and adjust
the refrigerator.
CAUTION
WARNING
CAUTION
Excessive Weight Hazard
Use two or more people to move and install the
refrigerator. Failure to do so can result in back or
other injury.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the
refrigerator for cleaning or service, be sure to protect
theoor.Alwayspulltherefrigeratorstraightoutwhen
moving it. Do not wiggle or walk the refrigerator when
tryingtomoveit,asoordamagecouldoccur.
Explosion Hazard
Keepammablematerialsandvapors,suchas
gasoline, away from the refrigerator. Failure to do
socanresultindeath,explosion,orre.
Avoid placing the refrigerator near a heat source,
direct sunlight, or moisture.
Phillips-Head
Screwdriver (+)
Flat-Head
Screwdriver (–)
Socket Wrench
13/32 in. (10 mm)
(for bolts)
Hex Wrench
3/16 in. (4.75 mm)
(for middle hinge)
Hex wrench
5/32 in. (4 mm)
(for middle hinge shaft)
DA99-01921A (EN-1).indd 10 2010.3.16 1:7:20 PM