13
REFRIGERATOR INSTALLATION
REVERSING THE DOORS
1. Remove the refrigerator and freezer doors as described
on pages 11 and 12.
2. Remove two screws and front leg cover from the
bottom of the refrigerator.
3. Remove the cap from the back side of the leg cover
and insert it into the opening on the opposite rear side.
4. Remove four bolts and the left and right bottom hinge
assemblies from the bottom of the refrigerator.
5. Unscrew the leg from the right bottom hinge. Using a
5/32-in. (4-mm) hex wrench, separate the hinge shaft
from the right hinge bracket.
6. Turn the right bracket over and reinstall the hinge shaft
in the bracket. Tighten the hinge shaft with the 5/32-in.
(4-mm) hex wrench. Thread the leg back into the op-
posite side of the hinge bracket.
7. Reinstall the two bottom hinges on the bottom of the
refrigerator and secure with the four bolts.
NOTE: These hinges should be installed opposite from
where they were removed.
8. Remove screw and door stopper from the right-bottom
sideofthefreezerdoor,ipit,andreinstallitonthe
left-bottom side of the freezer door.
Cap Cap
ENGLISH
DA99-01921A (EN-1).indd 13 2010.3.16 1:7:27 PM