Levelling
Before you install the dryer, make sure you have read Installation requirements on page 15. Please note that the following instructions are for installation without using a drain hose. For instructions for using a drain hose, see the next section, Drain hose (if necessary). For convenience, consider installing the dryer next to your washer.
1. Gently put the dryer on the desired
Alocation.
2. Use a level (A) and check the levelness of the dryer from side to side and front to back.
3. If the dryer is not level, adjust the levelling leg (B). Turning the leg
4. Once the dryer is level, make sure the dryer stands firmly on the floor.
5. Plug in the dryer.
B |
Installation
C
NOTE
•The dryer can be levelled using either
or both of the front and rear legs of the dryer.
D• To set the dryer to the same height as the washer, fully retract (C) the levelling legs by turning them counter clockwise, then loosen (D) the legs by turning them clockwise.
•Extend the levelling leg only as much as necessary. Extending the levelling leg more than necessary can cause the dryer to vibrate.
English 17
