Chapter 2
C O N N E C T I O N S
Choosing a Connection
The following shows examples of connections commonly used to connect the DVD player with a TV and other components.
Before Connecting the DVD Player
-Always turn off the DVD player, TV, and other components before you connect or disconnect any cables.
-Refer to the user’s manual of the additional components (such as a TV) you are connecting for more information on those particular components.
Connection to a TV (Video)
1
Using Video/Audio cables, connect the VIDEO (yellow)/AUDIO (red and white) OUT terminals on the rear of the DVD player to the VIDEO (yellow)/AUDIO (red and white) IN terminals of your TV.
2
Turn on the DVD player and TV.
3
Set the Video Output to
You can also use the VIDEO SEL. button to change the Video Output mode. (See page 12)
RED |
|
|
|
| WHITE | YELLOW | ||||
|
|
|
| Audio Cable | Video Cable | |||||
|
|
|
|
|
|
|
|
|
| |
RED |
|
|
|
| WHITE | YELLOW | ||||
|
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
4
Press the input selector on your TV remote control until the
Video signal from the DVD player appears on the TV screen.
Note
-Noise may be generated if the audio cable placed too close to the power cable.
-If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 18 to 19)
-The number and position of terminals may vary depending on your TV set. Please refer to the user's manual of your TV.
-If there is one audio input terminal on the TV, connect it to the [AUDIO OUT][left] (white) terminal of the DVD player.
-If you press the VIDEO SEL. button when DVD Player is in stop mode or no disc is inserted, the Video Output mode changes in the following sequence:
When HDMI is connected, only
-If you set the HDMI output resolution to 720p or 1080i, the
